Modifying Columns

Introduction

The right-click context menu available in the column header gives you the ability to modify the columns you use and the order in which they display. The modifications you apply using this procedure remain as your column settings until you choose to modify them again or to restore the Synapse default settings.

Note:

Each of the following options can be configured independently for each Worklist.

Steps

1. Right-click in the column header to display the menu options.
2. Click Column Selector. The Column Selector dialog box opens.
3. Select columns as needed between the Available list and the Selected list. The following table describes the options available within the Column Selector dialog box.

Field Name	Description
Available	The columns that display in the Available list are not currently visible, but can be added to it. Click to select a column in the Available list. Click the right-facing arrow to add your selection to the Selected list. Use the up and down arrows to change the placement of the selected columns. By default, a newly added column displays at the bottom of the Selected list.
Selected	The column names in the Selected list are the ones that currently display. To remove a column, select the column name and use the left-facing arrow to move the selected column to the Available list. Note: If you designate a column for use in sorting and filtering, you cannot remove the column.

4. Click Save and Close when you are finished modifying columns.

Related Topics

Using the Column Header Context Menu