Configuring Cine Settings

Introduction

You can configure the following settings in the Cine settings tab:

• General Setting
• Multiframe Settings
• Non Multiframe Settings

Path

Settings > Image Display > Cine

Steps

1. Modify the following settings as needed.
   

2. When you have finished configuring all settings, click Close to apply and save setting changes.

General Setting

Use the following setting to configure single-image speed.

Note:

Single Image Speed applies to MG (non-Tomo), CR, DX, IO, RT, and RF when there are no DICOM Header Frame Times available in these image types. Single Image Speed also applies to Bookmark and single frame images series.

Setting	Description
Single Image Speed (Sec)	In the text box, enter a number for the image speed between 1 and 30 seconds. The default value is 1.

Top

Multiframe Settings

Use the following settings to configure multiframe images and series to automatically play and loop during scroll.

Note:

A multiframe viewport applies to: Angiographic Image Storage Ultrasound Multiframe Image Storage Multiframe Grayscale Byte Secondary Capture Image Storage Multiframe True Color Secondary Capture Image Storage

Setting	Description
Auto-play	The Auto-play setting has the following options: Off: Default setting. On: Synapse automatically plays cine when you open a study with multiframe images. If a study has one of the multiframe viewport image types listed above, all viewports can auto-play simultaneously. If the study has multiframe DICOM data of another type, such as BT, RF, or NM, then only the first viewport can auto-play since simultaneous playback is only supported for a multiframe viewport. Note: Auto-play does not occur for All Images series. On cache complete (requires Hybrid Mode) : If you select this option and Hybrid Mode is enabled, the Viewer delays auto-play (cine start) until the image has downloaded.
Loop during scroll	Use this option to control looping while you scroll in a multiframe viewport, allowing you to scroll through to the edge of a loop. See Using Looping During Scroll. This setting is disabled by default.

Top

Non Multiframe Settings

Use the following settings to select a modality and configure the default cine speed (measured in frames-per-second) for non multiframe images and series that do not have a predefined DICOM frame rate.

Setting	Description
Modality	Select one of the following options: CT MG MR NM PT Other As you select a modality, the Default speed (fps) field is updated.
Default Speed (fps)	In the text box, enter a number for the default speed between 0.5 to 120. The default value is 31, except for MG (Tomo), which is 25 fps.

Results

Synapse automatically saves any updated options and displays the following message in the bottom left corner of the window: Successfully saved.

Synapse displays the following message that you must take the following action to apply the settings: Refresh the Synapse browser window for settings to apply.

Top

Related Topics

Cine Overview

Using Cine

Configuring Image Display Settings

Configuring Workstation Cache