Configuring MG Near Match
Introduction
You can customize the MG Near-Match settings to specify which reading protocols Synapse adds to the Reading Protocols drop-down list for each study. The Near-Match setting is only available for the MG modality. You can configure the following settings in the MG Near-Match settings tab:
Path
User Settings > Reading Protocols > MG Near-Match
Steps
- Modify the following settings as needed.
- When you have finished configuring all settings, click Close to apply and save setting changes.
MG Near-Match Settings
|
Setting |
Description |
|---|---|
|
Enable near-match |
If enabled, Synapse displays the following additional MG Near-Match settings. This setting is enabled by default. |
Near-Match Rules
|
Setting |
Description |
|---|---|
|
Near-match series, same procedure code |
If enabled, Synapse displays matching reading protocols for studies that have the same procedure code, but considers near- match series boundaries. The number of series can be different as configured in the Near-Match Series Boundaries settings. This setting is enabled by default. |
|
Any series, same procedure code |
If enabled, Synapse displays matching reading protocols for studies that have the same procedure code, but does not consider near- match series boundaries. |
|
Near-match series, any procedure code |
If enabled, Synapse displays reading protocols that ignore the procedure code, but considers near- match series boundaries. The number of series can be different as configured in the Near-Match Series Boundaries settings. This setting is enabled by default. |
Near-Match Series Boundaries
|
Setting |
Description |
|---|---|
|
Number of series more than reading protocol |
If enabled, Synapse specifies how many additional series can be in a study for Synapse to display a study using a series- based reading protocol that has a defined number of series with specific names. Synapse displays these extra series as additional steps. If applicable, select a different number from the drop-down list of 1 through 6. The default setting is 3. |
|
Number of series less than reading protocol |
If enabled, Synapse specifies how many fewer series can be in a study for Synapse to display that study using a series- based reading protocol that has a defined number of series with specific names. Synapse displays blank viewports for missing series. If applicable, select a different number from the drop-down list of 1 through 6. The default setting is 3. |
Results
Synapse automatically saves any updated options and displays the following message in the bottom left corner of the window: Successfully saved.
Synapse displays the following message that you must take the following action to apply the settings: Refresh the Synapse browser window for settings to apply.